Cements

Cements

Used to determinate the specific surface of cement by simple calculations that consist in measuring the time required by the air to pass between two levels marked on the manometer tube.

Used to precrush the materials destined to chemicalor physical tests.

Used to determine the setting time of normal cement pastes.

Is used to study the setting time of hydraulic binders. It working is intermittent and it is fitted with a device for recording the penetration of the plunger into the paste.

The electronic automatic penetrometer measures and records on a continuous gradual increase of the consistency of the dough cement or any other similar material.

EN 196/1

With ground surfaces, made of steel. Locking with screw knob. Used for the preparation of 40x40x160 mm specimens.

Used to mix mortar and cement, for the preparation of sample tested ultimate flexion/compression.

Used to mix mortar and cement, for the preparation of sample tested ultimate flexion/compression.

Used lo determine the flexural strength of 40x40x160 mm mortar specimens and the tensile strength of briquettes.

Equipment developed for measurement of mechanical strength of the adherence of adhesive.

Equipment developed for measurement of mechanical strength of the adherence of adhesive.

The machines series has been designed and built specifically to meet the needs of those who want to carry out tests on compression mortars and cements in building site laboratories; features of these machines are: assembled frame without welds, temperate compression plates, hardened and ground steel, robustness, precision of measurement, ease to use and transport, the perfect compliance with new Standards. The modularity has been interpreted in the full sense of its meaning. The housing piston load was obtained in the lower part of the machine. The purchase of the various components of the press can meet the demands of multiple versions of the machine.

EN 196/1

Used fo the performance of compression tests on 40x40x160 mm specimens.

The compression device is inserted between the compression platens of the machine, that are made of special highhardness and ground steel.

Dimensions: 150x180mm(Diam. X heigth)

Weight: 10 kg

Used for testing 40x40x160mm specimens.

Distance between supports: 119mm

Used for the measurement of linear variations up lo 300 mm of plastic mortar specimens, prepared forthe autoclave expansion test.

This equipment has been specially designed to make the entire test cycle automatically.

Page 1 of 2